YouTube:
Instagram:
Facebook:
Twitter:
...
Alex Whitworth - 20/07/2022 - 16:59
... direct-injection engine can also more accurately monitor the air/fuel mixture entering the engine, as the fuel is squirted in neat, not mixed with air before entering the engine. They can even add fuel at different points in ...
Simon Hancocks - 20/01/2020 - 10:03 - 0 comments
... crank to actuate the valves, a camless engine uses air pressure above and below a piston that is connected to the valve to operate ... the outlet, C is the locking pin and D is the below-piston air reservoir. Two open the valve a signal will pass to a valve allowing a ...
Simon Hancocks - 18/02/2020 - 12:11 - 2 comments
... causes on older engines A lean running engine has an air/fuel ratio that has too little fuel and too much air in the mixture. When this happens, the combustion in the chamber can be too ...
Simon Hancocks - 24/07/2020 - 12:30 - 0 comments
... from a jet aircraft, a 200-section rear tyre and a ram-air snout that could snaffle a pigeon whole. It also came with the worst ... Servicing falls generally every 4000 miles. KLEEN AIR REMOVAL Some owners have removed the KLEEN air injection system in the ...
Anonymous (not verified) - 10/05/2024 - 04:26 - 0 comments
... bolt and tightening it. Most modern trail bikes have an air bleed screw at the top of the forks. Long travel off-road forks can draw air in past their seals as fully-compressed sliders rebound, and this builds ...
Anonymous (not verified) - 10/05/2024 - 04:24 - 0 comments
... lines or replacing seals, you need to bleed all the trapped air out after the work. Here are five essential tips on bleeding your ... against the pressure, loosen the nipple, let the old fluid/air out, tighten the nipple, then release the lever and repeat till (no) fade. ...
Visordown - 23/09/2019 - 09:35 - 0 comments
... a spill. Or you may want to change the oil and adjust the air gap. Whatever the reason, removing forks isn't that hard. What's ... longtermer - enough to change the oil or adjust the air gap will require a few specialist tools. We got a kit from K-Tech, the ...
rgo - 10/05/2024 - 04:15 - 0 comments
•UPPER: LORICA •LINING: BREATHABLE AIR MESH •SLIDER: STEEL •FRONTSIDE PROTECTION: FLEXIBLE SHOCK ... •HEEL PROTECTION: SHOCK ABSORBER INSERT ON THE HEEL •AIR INTAKE: FRONTSIDE AND HEEL BACKSIDE WITH AIR INTAKES. ON POSITION GRANTS ...
Anonymous (not verified) - 19/09/2018 - 03:49 - 0 comments
... supercharger, the basic idea is the same. By compressing air before it enters the cylinders, more air and fuel can be forced into them. That means when the spark plug ignites ...
Visordown Corre... - 09/09/2019 - 03:05 - 0 comments