Haynes Manual to Plain English

5 messages
06/01/2005 at 15:46
Haynes Manual Terminology Translated into Common English
Haynes: Rotate anticlockwise.
Translation: Clamp with molegrips then beat repeatedly with hammer anticlockwise.


Haynes: This is a snug fit.
Translation: Clamp with molegrips then beat repeatedly with hammer.

Haynes: This is a tight fit.
Translation: Clamp with molegrips then beat repeatedly with a hammer.

Haynes: As described in Chapter 7...
Translation: That'll teach you not to read through before you start. Now you are looking at scary photos of the inside of a gearbox.

Haynes: Pry...
Translation: Hammer a screwdriver into...

Haynes: Undo...
Translation: Go buy a tin of WD40 (giant economy size).

Haynes: Retain small spring...
Translation: PINGGGG - "Jesus, where the hell did that go?"

Haynes: Press and rotate to remove bulb...
Translation: OK - that's the glass bit off, now fetch some good pliers to dig out the bayonet part (and maybe a plaster or two).

Haynes: Lightly...
Translation: Start off lightly and build up till the veins on your forehead are throbbing then clamp with molegrips then beat repeatedly with hammer.

Haynes: Weekly checks...
Translation: If it isn't broken don't fix it.

Haynes: Routine maintenance...
Translation: If it isn't broken, it's about to be. We warned.

Haynes: One spanner rating.
Translation: An infant could do this... so how did you manage to **** it up?

Haynes: Two spanner rating.
Translation: Now you may think that you can do this because two is a low, teensy weensy number... but you also thought the wiring diagram was a map of the Tokyo underground (in fact that would have been more use to you).

Haynes: Three spanner rating.
Translation: Make sure you won't need your car for a couple of days.

Haynes: Four spanner rating.
Translation: You're not seriously considering this are you?

Haynes: Five spanner rating.
Translation: OK - but don't ever carry your loved ones in it again.

Haynes: If not, you can fabricate your own special tool like this...
Translation: Hahahahahahahahahahahahahahahahahahahahahahaha.

Haynes: Compress...
Translation: Squeeze with all your might, jump up and down on it, throw it at the garage wall, then find some molegrips and a hammer...

Haynes: Inspect...
Translation: Squint at really hard and pretend you know what you are looking at, then declare in a loud knowing voice to your wife "Yep, as I thought, it's going to need a new one"

Haynes: Carefully...
Translation: You are about to suffer deep abrasions.

Haynes: Retaining nut...
Translation: Yes, that's it, that big spherical blob of rust.

Haynes: Get an assistant...
Translation: Prepare to humiliate yourself in front of someone you know.

Haynes: Turning the engine will be easier with the spark plugs removed.
Translation: However, starting the engine afterwards will be much harder. Once that sinking pit of your stomach feeling has subsided, you can start to feel deeply ashamed as you gingerly refit the spark plugs.

Haynes: Refitting is the reverse sequence to removal.
Translation: Yeah, right. But you swear in different places.

Haynes: Prise away plastic locating pegs...
Translation: Snap off...

Haynes: Using a suitable drift...
Translation: Clamp with molegrips then beat repeatedly with hammer.

Haynes: Everyday toolkit
Translation: RAC Card & Mobile Phone

Haynes: Apply moderate heat...
Translation: Unless you have a blast furnace, don't bother. Alternatively, clamp with molegrips then beat repeatedly with hammer.

Haynes: Index
Translation: List of all the things in the book, bar what you need to do.

[X] Should be in humour
06/01/2005 at 15:53
WiseBuddha wrote
....[X] Should be in humour

[X] Has been in humour several times.

Still funny, though
06/01/2005 at 16:05
Haynes: detach fuel hose from fuel pump, using a rag to soak up any extra petrol

Translation: detach fuel hose from pump, start panicing when you realise the rag is now soaking with petrol and that the fuel tap must be broken. Hurridley slip the fuel hose back onto the fuel pump slicing finger in process and pretend to the next door neighbour whos watching that isnt petrol flowing down the driveway, just water...

www.karateglasgow.com

06/01/2005 at 16:10
What scarier in haynes now do a sex manual.

Imaging

insert in orofice, repeat as necessary

Visordown Elefantentreffen 2007
06/01/2005 at 16:50
There's a wonderful section in the Mini haynes manual about removing tapered ball joints it reads something like:

Quote
To remove the joint use part number BL354338 as detailed in the following sections.

described in fairly long detail over several paragraphs

Alternatively if you don't have access to special tool BL354338 remove the nut and hit the joint firmly with a well weighted hammer.

Your say
email image
5 messages
Forum Jump